Resultados 1 al 6 de 6

Tema: Frsky XM+ binding /firmware flashing issue

  1. #1
    Nuevo Usuario
    Fecha de ingreso
    22 dic, 18
    Mensajes
    3

    Frsky XM+ binding /firmware flashing issue

    Hi guys, I'm so frustrated please help. I can't find this problem mentioned anywhere. After issue after issue after issue after issue I managed to fly for 10 sec and I hard landed. Quad rolled and wasn't able to rearm anymore (also osd disappeared but that's another story I guess). On the bench: rx didn't show any sign of life. Rewired it and it powers on now. Doesn't bind though. Rebound, nothing. Steady red led and while I press the bind/fs button the green led flashes weakly, I release the button and only red led stays on steady.
    Tried to reflash with all sorts of firmware on both ports (bottom S.Port and back ext. Port) on my Taranis X7. I did this many times always worked. Nothing. It shows this message I never saw
    "FW update error Bottom pin no resp"
    The pins are connected in the right order on both attempts (inverted +- on back port).
    I have an FCC firmware on the TX but tried also the LBT fw just for the fuck of it and nothing seems to work.
    I hope somebody had the same issue. Please avoid saying is faulty or is broken. I know it is just if you can think of a solution.
    Thanks a lot guys and sorry for my frustration

    Inviato dal mio SM-G960F utilizzando Tapatalk

  2. #2
    Tricopter Member
    Fecha de ingreso
    09 nov, 18
    Mensajes
    46

    Actualizar receptor FrSky XM+

    Mira este video. Look at this video.



    Un saludo. A greeting

  3. #3
    Nuevo Usuario
    Fecha de ingreso
    22 dic, 18
    Mensajes
    3
    Thanks I did check this before and already did but didn't work :-(

    Inviato dal mio SM-G960F utilizzando Tapatalk

  4. #4
    Tricopter Member
    Fecha de ingreso
    09 nov, 18
    Mensajes
    46
    It was what you asked for, it could also be that the receiver has broken down and you will have to buy another one, if you do not see anything broken (antenna cable, cracked printed circuit, etc.)

    https://oscarliang.com/flash-frsky-rx-firmware/

    a greeting

    Era lo que tu pedías, también puede ser, que se haya estropeado el receptor y tendrás que comprar otro, si no ves nada roto( cable de antena, circuito impreso rajado, etc.)

    https://oscarliang.com/flash-frsky-rx-firmware/

    Un saludo
    Última edición por fjbf98; 23/12/2018 a las 18:13

  5. #5
    Nuevo Usuario
    Fecha de ingreso
    22 dic, 18
    Mensajes
    3
    No it's not what I asked for but thank you anyway

    Inviato dal mio SM-G960F utilizzando Tapatalk

  6. #6
    Nuevo Usuario
    Fecha de ingreso
    11 ene, 19
    Mensajes
    3
    Cita Iniciado por ItoSan Ver mensaje
    No it's not what I asked for but thank you anyway

    Inviato dal mio SM-G960F utilizzando Tapatalk
    Tengo el mismo problema y no logro solucionarlo, ya no se donde buscar. Si consigues la solución compártela por aquí.

Permisos de publicación

  • No puedes crear nuevos temas
  • No puedes responder temas
  • No puedes subir archivos adjuntos
  • No puedes editar tus mensajes
  •